- Remove the tire and wheel assembly.
- Remove the rotor and caliper assembly.
- Inspect the wheel hub if there is enough space for the studs to
pull
out.
- Remove the hub and bearing assembly if
necessary.
- Using equivalent wheel stud remover tool or
hammer,
remove and discard the wheel stud(s).
- Insert the new stud from the rear of the hub.
- Install flat washers and nut (flat side down),
onto
the wheel stud, then tighten until the wheel stud is fully seated.
Use a light oil on the washers and nut to ease
the
installation procedure. 
|
|
|
