You are here: Home > How To Install
  1. Remove the tire and wheel assembly.
  2. Remove the rotor and caliper assembly.
  3. Inspect the wheel hub if there is enough space for the studs to pull out.
  4. Remove the hub and bearing assembly if necessary.
  5. Using equivalent wheel stud remover tool or hammer, remove and discard the wheel stud(s).

 

  1. Insert the new stud from the rear of the hub.
  2. Install flat washers and nut (flat side down), onto the wheel stud, then tighten until the wheel stud is fully seated.

Use a light oil on the washers and nut to ease the installation procedure.